Generation

BMW 7 Series 1995–2001

Change

Bolt pattern PCD 5x120 5 mounting holes on a 120 mm pitch circle

Centre bore DIA 72.5 millimetres

Wheel offset ET 20 mm

Fasteners M12x1.50 Bolt

Tightening torque 120 N·m

Tyre pressure —

Before buying: Match PCD and centre bore precisely. Also check wheel offset and width against your VIN.

All tyre sizes

These options apply only to the stated years, markets and trim levels. Check the size against the vehicle placard and handbook before buying.

215/65 R16 98V7J×16, ET not confirmedData depends on the version; no reliable value has been establishedNot established
235/60 R16 100W8J×16, ET not confirmedData depends on the version; no reliable value has been establishedNot established
235/50 ZR18 (indices depend on the tyre)8J×18 front, 9.5J×18 rear; ET not confirmedNot establishedNot established
235/50 ZR18 front, 265/45 ZR18 rear (indices depend on the tyre)8J×18 / 9.5J×18; ET unconfirmedNot establishedNot established
For some versions, the manuals specified, for example, 2.0 bar (200 kPa / 29 psi) at the front and 2.4 bar (240 kPa / 35 psi) at the rear under normal load, but these values cannot be applied to all E38 models: other requirements are found depending on the engine, tyres, speed and load. Values for full load or sustained high-speed driving must not be given without a table specifically for this version.

Exact match: 5x120 and 72.5 mm

Show all