
Generation
MG Midget 1961–1979
Change
Bolt pattern PCD
4x101.6
4 mounting holes on a 101.6 mm pitch circle
Centre bore DIA
65.1
millimetres
Wheel offset
ET 16
mm
Fasteners
3/8 UNF
Nut
Tightening torque
—
Tyre pressure
—
Before buying: Match PCD and centre bore precisely. Also check wheel offset and width against your VIN.
Tyres and wheels by version
These options apply only to the stated years, markets and trim levels. Check the size against the vehicle placard and handbook before buying.
- In brief: the MG Midget 1961–1979 came with 145‑13 as standard and, on later cars, 155/70 R13. The exact load/speed indices and wheel offsets are usually not specified in the factory specifications available for these years—I won’t assume them. The pressures below are for cold tyres; before driving, check the placard on the specific car and the manual for its market.
- 1961–1964, Mk I (until 1964)5.20‑13, cross-ply; load/speed index not specified13 × 4J; offset not specified165 / 165 kPa (1.65 / 1.65 bar; 24 / 24 psi)
- 1964–1974, Mk II–III145‑13, radial; indices not specified13 × 4J; offset not specified165 / 165 kPa (1.65 / 1.65 bar; 24 / 24 psi)
- 1974–1979, late-production Mk III / 1500155/70 R13, radial; indices not specified13 × 4.5J; offset not specified165 / 165 kPa (1.65 / 1.65 bar; 24 / 24 psi)
- For increased loads or prolonged high-speed driving, some values in the factory data vary by market and version; they cannot be reliably confirmed for the entire range. 5.20‑13 and 145‑13 are not sizes with the modern indices specified, while 155/70 R13 is the modern metric notation for a later low-profile size.
Vehicles with the same PCD and centre bore
0matchesExact match: 4x101.6 and 65.1 mm
No other vehicles found.