Generation
Opel Kadett 1973–1979
Change
Bolt pattern PCD
4x100
4 mounting holes on a 100 mm pitch circle
Centre bore DIA
57.1
millimetres
Wheel offset
ET 31
mm
Fasteners
M12x1.50
Nut
Tightening torque
—
Tyre pressure
—
Before buying: Match PCD and centre bore precisely. Also check wheel offset and width against your VIN.
Tyres and wheels by version
These options apply only to the stated years, markets and trim levels. Check the size against the vehicle placard and handbook before buying.
- Standard versions, base trim145 SR 134½J×13; offset unconfirmedFront: 160 kPa / 1.6 bar / 23 psi; rear: 180 kPa / 1.8 bar / 26 psi
- Standard versions, alternative fitment155 SR 135J×13; offset unconfirmedFront: 160 kPa / 1.6 bar / 23 psi; rear: 180 kPa / 1.8 bar / 26 psi
- Versions with higher tyre requirements165/70 SR 135J×13; offset unconfirmedThe pressure for this combination has not been reliably established based on the available data
- Rallye / GT/E — depends on year and market175/70 HR 13 appears in cataloguesUsually 5½J×13; offset unconfirmedPressure depends on version and conditions; no reliable factory table has been established
Vehicles with the same PCD and centre bore
47matchesExact match: 4x100 and 57.1 mm
- Audi 80 1978–1986 ET 45
- Audi A2 1999–2005 ET 45
- BMW 2000C-CS-CA 1965–1969 ET 16
- BMW 3 Series 1982–1990 ET 35
- BMW 3 Series 1975–1982 ET 16
- BMW Z1 1989–1991 ET 25
- Chery Amulet 2003–2016 ET 38
- Opel Ascona 1975–1981 ET 37
- Opel Ascona 1970–1975 ET 37
- Opel Kadett 1965–1973 ET 37
- Opel Manta 1975–1988 ET 37
- Opel Manta 1970–1975 ET 31
